Home · Calculators

Mass from volume and density calculator

No moisture correction.

Worked examples

Example 1: Concrete

0.5 m³ of normal-weight concrete at 2,400 kg/m³ is 1,200 kg.

Example 2: Sand stockpile

2.4 m³ of dry sand at about 1,600 kg/m³ (loose) is 3,840 kg, just under 4 tonnes. Wet sand is heavier, so ask the supplier for the bulk density.

Reading the result

Use the bulk density for loose materials and the particle or solid density for solid items. They can differ by 30% or more.

For lifting, add the rigging and any attachments, and use a verified mass from the supplier where it exists.

Mass from density is the starting point for lifting plans, delivery loads and floor loading checks. Use the supplier’s figure where one exists.

Typical values

MaterialDensity (kg/m³, typical)
Normal-weight concrete2,400
Reinforced concrete2,500
Steel7,850
Water1,000
Dry sand (loose)about 1,600
Softwood timberabout 500

Common mistakes

  • Using a solid density for a loose material.
  • Forgetting moisture, which can add 10% or more for sand and timber.
  • Using gross volume for hollow sections.

How to use

Enter a volume in cubic metres and a density in kg/m³. The result is the mass in kilograms. Use this for any material where you know the volume, such as concrete, timber, water or soil.

Scope: For steel plate or bar, the dedicated plate and rebar pages already include the steel density.

Edge cases

  • Zero volume gives zero mass. Zero or negative density is rejected.
  • Densities vary with moisture, compaction and mix. Use the supplier’s or the site’s figure where you have one.
  • The result is a mass, not a weight in newtons. Multiply by 9.81 for a force in newtons.

Typical densities

Materialkg/m³
Normal-weight concrete2,400
Reinforced concrete (allowing for steel)2,500
Water1,000
Softwood, dry450–550
Compacted granular fill1,900–2,100

Questions

What does 0.2 m³ of softwood weigh?

At about 500 kg/m³ it is about 100 kg.

And 1.5 m³ of water?

1,500 kg, or about 14.7 kN as a load.

Why does the soil figure vary so much?

Soil density depends on moisture, grading and compaction. A loose dry sand may be around 1,600 kg/m³ and a compacted wet clay over 2,000 kg/m³. For haulage, use the loose density of the excavated material; for a retaining wall load, use the in-place density from the ground investigation.

Basis

This tool uses the formula shown under Method. It is standard arithmetic or physics and relies on no external data set or design standard, so check any values you enter against your own project data.

Last checked 14 October 2026. See the disclaimer.