Home · Calculators

Rebar weight calculator

Round bar at 7,850 kg/m³.

Worked examples

Example 1: 16 mm bar

1.578 kg/m, so a 12 m bar is 18.94 kg. d²/162 gives 1.580 kg/m.

Example 2: 12 mm bar

0.888 kg/m, so 6 m is 5.33 kg. d²/162 gives 0.889 kg/m.

Reading the result

Use nominal diameters. Ribs are allowed for in the nominal mass of standard bars, so the figure is close to schedule values.

For a bar schedule, multiply by the number of bars and include laps and bends.

The kg/m figures in the table are πd²/4 × 7,850. They agree with the nominal masses printed on bar schedules to within about 0.001 kg/m.

Typical values

Bar sizekg/m (nominal)
8 mm0.395
10 mm0.617
12 mm0.888
16 mm1.578
20 mm2.466
25 mm3.853
32 mm6.313

Common mistakes

  • Using the overall length without laps and bends from the schedule.
  • Mixing bar mark quantities when summing a schedule.
  • Rounding the per-metre figure too early on large tonnages.

How to use

Enter the bar diameter in millimetres and the total length in metres. The result is the mass per metre and the total mass, using 7,850 kg/m³. The page also shows the site rule of thumb d²/162.

Edge cases

  • Zero or negative diameter is rejected. Zero length gives zero total mass.
  • Nominal diameters are used. Ribs are allowed for in the nominal size, so the mass per metre matches published tables closely.
  • Laps, hooks and bends add length. Take them from the bending schedule rather than the drawing dimension.

Mass per metre

Diameter (mm)kg/m
80.395
100.617
120.888
161.578
202.466
253.853
326.313

Questions

How accurate is d²/162?

For a 16 mm bar it gives 1.580 kg/m against 1.578 kg/m, within 0.2%.

What is the mass of a tonne of 12 mm bar in metres?

At 0.888 kg/m, one tonne is about 1,126 m of bar.

Does the schedule weight include laps?

Only if the bar lengths on the schedule include them. A bending schedule normally lists cut lengths, which include laps and bends, so multiplying the total cut length by the kg/m gives the delivered weight. Allow separately for tying wire and chairs.

How do I estimate reinforcement for a slab quickly?

Early-stage estimates often use kg of steel per m³ of concrete from similar projects, but these vary widely. For a figure you can rely on, take bar sizes and lengths from the schedule and use this page.

Basis

This tool uses the formula shown under Method. It is standard arithmetic or physics and relies on no external data set or design standard, so check any values you enter against your own project data.

Last checked 14 October 2026. See the common-calculations note and the disclaimer.