Steel weight calculator
Plate, round bar and hollow sections. No holes or coatings.
Worked examples
Example 1: Plate
2 m × 1 m × 10 mm is 157 kg.
Example 2: Larger plate
2.4 m × 1.2 m × 12 mm is 271 kg.
Reading the result
Holes and cut-outs are not deducted.
Stainless steel is slightly heavier (about 7,900–8,000 kg/m³); aluminium is about a third of the mass.
A handy check: carbon steel plate weighs 7.85 kg per square metre per millimetre of thickness. A 10 mm plate is 78.5 kg/m², so 2 m² is 157 kg.
Typical values
| Thickness (mm) | Mass per m² of steel plate |
|---|---|
| 3 | 23.6 kg |
| 6 | 47.1 kg |
| 10 | 78.5 kg |
| 12 | 94.2 kg |
| 20 | 157.0 kg |
| 25 | 196.3 kg |
Common mistakes
- Entering thickness in metres in the millimetre box.
- Forgetting to deduct large cut-outs on a profiled plate.
- Using carbon-steel density for stainless or aluminium.
How to use
Enter the plate length and width in metres and the thickness in millimetres. The tool assumes carbon steel at 7,850 kg/m³ and a solid rectangle. For a plate with a large opening, work out the opening as a second plate and subtract it.
Scope: This page is for flat plate. For round bar use rebar weight; for any other shape or material use mass from density.
Edge cases
- Zero or negative dimensions are rejected: a plate needs a real length, width and thickness.
- Very thin sheet (under 1 mm) is fine arithmetically, but coated sheet carries zinc or paint mass the tool ignores.
- For chequer plate, the raised pattern adds mass; use the supplier’s kg/m² figure.
Questions
Why 7,850 kg/m³?
It is the usual design density for carbon and low-alloy structural steel. Suppliers quote figures between about 7,800 and 7,870 kg/m³, a difference under 1%.
How heavy is a 1.5 m × 3 m × 6 mm plate?
1.5 × 3 × 0.006 × 7,850 = 212 kg, so it needs a lifting plan rather than two people.
How do I deduct a hole?
Work out the mass of the hole as a plate of its own and subtract it. A 100 mm square cut-out in a 10 mm plate is 0.1 × 0.1 × 0.01 × 7,850 ≈ 0.79 kg. For round holes, use πd²/4 for the area. Small bolt holes are usually ignored for lifting but counted for a fabrication weight.
Basis
This tool uses the formula shown under Method. It is standard arithmetic or physics and relies on no external data set or design standard, so check any values you enter against your own project data.
Last checked 14 October 2026. See the common-calculations note and the disclaimer.