Home · Calculators

Drawing scale converter

From the drawing to site, or from site to the drawing.

Worked examples

25 mm measured on a 1:50 drawing is 25 × 50 ÷ 1,000 = 1.25 m on site. A 6 m wall on a 1:100 plan is 6 × 1,000 ÷ 100 = 60 mm long.

Before you scale from a drawing

Use the stated dimensions first. A printed PDF may not be at its original size, so check the scale bar against a known dimension. Many drawings say not to scale from them, and that instruction takes priority over this tool.

Common scales

Scale1 mm on the drawing is1 m on site draws atTypical use
1:55 mm200 mmDetails
1:2020 mm50 mmSections and details
1:5050 mm20 mmFloor plans and sections
1:100100 mm10 mmFloor plans and elevations
1:200200 mm5 mmBlock and general arrangement plans
1:500500 mm2 mmSite plans
1:12501.25 m0.8 mmLocation plans

Printed at the wrong size

Paper sizes in the A series halve in area at each step, so each step down scales lengths by about 0.71. A1 printed on A3 is two steps, a linear factor of 0.5. A 1:50 drawing printed that way becomes 1:100 on paper, even though the title block still says 1:50 at A1.

If a PDF has a scale bar, measure the bar first. Divide the real length it represents by the length you measure and you have the true scale of that print. Enter that in the tool rather than the figure in the title block.

Common mistakes

  • Reading a 1:100 scale rule on a 1:50 drawing, which doubles every length.
  • Trusting "fit to page" in a PDF viewer, which changes the scale without any warning on the sheet.
  • Mixing up units. This tool takes millimetres on the drawing and metres on site.
  • Scaling a dimension that is stated on the drawing. A written dimension takes priority over a measured one.

Questions

How big is a 900 mm door on a 1:50 plan?

0.9 × 1,000 ÷ 50 = 18 mm.

What does 37 mm measure at 1:200?

37 × 200 ÷ 1,000 = 7.4 m on site.

Basis

This tool uses the ratio shown under Method. It is plain arithmetic and relies on no external data set or design standard.

Last checked 9 November 2026. See the methodology and the disclaimer.