Lifting sling capacity screen
Check a multi-leg sling arrangement using the uniform load method factors.
Worked example
A 2 t load on a two-leg sling with 1.6 t legs at 30° to the vertical. The factor is 1.4, so the rated capacity is 1.4 × 1.6 = 2.24 t, and the load uses 89% of it.
Measuring the angle
The angle here is from the vertical to one leg, not the included angle between two legs. Two legs with a 90° included angle are each at 45° to the vertical. Above 60° to the vertical the tool refuses a result.
| Legs | Up to 45° | Over 45° to 60° |
|---|---|---|
| Single | 1.0 | |
| Two | 1.4 | 1.0 |
| Three | 2.1 | 1.5 |
| Four | 2.1 | 1.5 |
When the method does not apply
- The load is uneven, or the centre of gravity is off-centre. Legs may then carry very different forces.
- The published symmetry limits are not met: legs at least 15° to the vertical, leg angles within 15° of each other, and plan angles within 15°.
- The sling is choked, basketed or passed round a sharp edge, each of which reduces the rating.
A trigonometric rating, n × WLL × cos β, applies only to a sling designed for a single purpose, so it is not used here.
Lifting is safety-critical. The appointed person, lift plan and the marked rating on the equipment govern. Under LOLER, lifts must be properly planned by a competent person.
More worked examples
Three-leg sling with 2 t legs at 40° to the vertical: the factor is 2.1, so the rated capacity is 4.2 t.
Four-leg sling with 1 t legs at 50° to the vertical: it is rated as a three-leg sling, and the factor for that band is 1.5, so the rated capacity is 1.5 t. The fourth leg adds nothing to the rating, because a four-leg lift can't be relied on to share evenly.
Why the angle matters
As legs spread, each carries more force to hold up the same load. For a two-leg lift sharing equally, the force in each leg is the load ÷ (2 × cos β).
| Angle to vertical | Included angle | Force in each leg, as a share of the load |
|---|---|---|
| 0° | 0° | 0.50 |
| 30° | 60° | 0.58 |
| 45° | 90° | 0.71 |
| 60° | 120° | 1.00 |
At 60° to the vertical each leg carries the full weight of the load. That is why the method stops there.
Common mistakes
- Entering the included angle, which is twice the angle to the vertical on a two-leg sling.
- Using the rating of a whole sling assembly as the single-leg WLL. Marked assemblies often state a rating for a range of angles, and that marking governs.
- Estimating the load instead of finding its weight, including any lifting beam and accessories.
- Assuming the centre of gravity is in the middle of the load.
Sources
Last checked 9 November 2026. See the methodology and the disclaimer.