Home · Calculators

Cantilever beam reactions and moment calculator

Statics at the fixed end of a cantilever. Not a section check, a deflection check or a fixing design.

Preliminary only. A cantilever also depends on its back-span or fixing to resist the moment; that is not checked here.

Worked examples

EXAMPLE 1: Balcony bracket

L = 2.5 m, w = 4 kN/m, P = 5 kN at the tip. R = 4 × 2.5 + 5 = 15 kN. M = 4 × 2.5² / 2 + 5 × 2.5 = 12.5 + 12.5 = 25 kN·m hogging at the root.

EXAMPLE 2: Canopy arm, uniform load only

L = 1.5 m, w = 10 kN/m, P = 0. R = 15 kN. M = 10 × 1.5² / 2 = 11.25 kN·m. The same total load as Example 1, but a shorter lever arm halves the moment.

Reading the result

The root moment is what governs the section size and the connection. It grows with the square of the length for a uniform load and linearly for a tip load, so a small increase in projection makes a large difference. The reaction tells you the vertical load the support must carry; the moment must be resisted by a couple at the fixing, for example a tension bolt group and a compression bearing, or a back-span with a hold-down.

The root moment acts with tension in the top fibre. Reinforcement or a timber notch in the wrong face is a classic error.

Typical values

EXAMPLE root moments for w = 5 kN/m, no tip load, computed with M = wL²/2:

Length L (m)Root moment (kN·m)
1.02.50
1.55.63
2.010.00
3.022.50

Common mistakes

  • Using the simply supported formula wL²/8 for a cantilever. The cantilever value wL²/2 is four times larger.
  • Forgetting the tip load from a parapet, handrail line load or person at the edge.
  • Mixing kN and N, or mm and m. Keep kN and m throughout.
  • Checking the member but not the fixing or back-span that must resist the moment.
  • Ignoring deflection and vibration, which often govern long cantilevers.

How to use

Enter the projection length in metres, the uniform load in kN/m and any point load at the free end in kN. Enter 0 where a load does not apply. The result gives the reaction and root moment; the method text states the shear at the tip.

Edge cases

  • Length must be greater than zero; loads may be zero but not negative.
  • A point load not at the tip is not covered: use M = P × a for its lever arm a and add it yourself.
  • A partial uniform load is not covered; split the problem or use analysis software.
  • Very large inputs over 10¹² are rejected.

Questions

Is the root moment the maximum moment?

For a uniform load and a tip load in the same direction, yes. Upward loads or a back-span change that.

What about tip deflection?

Use the beam deflection page, which includes a cantilever case.

Should I enter factored loads?

Enter whatever level you need. The tool applies no factors; state which you used when you record the result.

Sources

Last checked 17 October 2026. Preliminary figure only. See methodology and the disclaimer.